It is the policy of Murray
State University, in conjunction with the Office of Environmental
Safety & Health, to empower Murray State University employees
with training in the operation of atmospheric detection instrumentation
and proven methods to protect oneself from injury or illness that
could possibly occur in a confined space. The Confined Space Manual
is the main resource used in training.
Confined
Space Power Point Training Presentation
OBJECTIVE
The
following procedure is to insure the safe entry into a confined
space that any Murray State University employee may encounter on
the campus. Maintenance personnel and other MSU employees who have
the potential to be injured by entering a confined space during
their jobs should be familiar with and follow this procedure.
DEFINITION
:
A
confined space is a space that has any of the following characteristics:
a.
limited openings for entry and exit
b.
unfavorable natural ventilation
c.
not designed for continuous worker occupancy
d.
limited openings for entry and exit
Confined
space openings are limited primarily by size or location. Openings
are usually small, perhaps as small as 18 inches in diameter, and
are difficult to move through easily. Small openings may make it
very difficult to get needed equipment in or out of the spaces,
especially protective equipment such as respirators needed for entry
into spaces with hazardous atmospheres or life-saving equipment
when rescue is needed.
Unfavorable
natural ventilation:
Because
air may not move in and out of confined spaces freely due to the
design, the atmosphere inside a confined space can be very different
from the atmosphere outside. Deadly gases may be trapped inside,
particularly if the space is used to store or process chemicals
or organic substances that may decompose. There may or may not be
enough oxygen inside the confined space to support life, or the
air could be so oxygen rich that it is likely to increase the chance
of fire or explosion if an ignition source is present.
Not
designed for continuous worker occupancy:
Most confined
spaces are not designed for workers to enter and work in them on
a routine basis. They are designed to store a product, enclose materials
and processes, or transport products or substances. Therefore, occasional
worker entry for inspection, maintenance, repair, cleanup, or similar
tasks are often difficult and dangerous due to chemical or physical
hazards within the space.
STANDARD
OPERATING PROCEDURES FOR:
PERMIT
REQUIRED CONFINED SPACES
THESE SPACES
ARE LABELED ACCORDINGLY! HVAC UNITS AND AIR HANDLING
ROOMS ARE NOT CONSIDERED PERMIT REQUIRED SPACES! CONFINED
SPACES BELOW GRADE ARE IDENTIFIED BY A PAINTED 12" DIAMETER
CIRCLE.
COLOR CODE
BELOW GRADE AREAS ARE:
ELECTRICAL
- RED
SANITARY SEWER
- GREEN
STORM WATER
- BLUE
STEAM - WHITE
A
Permit-required Confined Space is a space that:
1) contains
or has the potential to contain a hazardous atmosphere
2) contains
a material that has the potential for engulfment
3) has
an internal configuration such that an entrant could be trapped
or asphyxiated by inwardly converging walls or by a floor that
slopes downward and tapers to a smaller cross section.
1. Before
entry into the confined space, the space must be vented with positive
ventilation. This ventilation must last at least 10 minutes -
no less. When this ventilation is taking place, all vehicles and
generators must be downwind and below grade of the opening of
the space if possible. This is because carbon monoxide is the
same weight as air but tends to settle in low spots.
2. After
properly venting the space, the personnel present needs to sample
the atmospheric conditions in the space from outside the entry
area using a direct read monitor. This can be done by lowering
a probe into the space. Monitor at the top, middle and bottom
of the space. Under no circumstance should any personnel be allowed
to carry the monitor into the space for pre-monitoring. The conditions
to be checked are the oxygen content (cannot be less than 19.5%
for safe entry), Carbon Monoxide level (below 50 ppm), and if
combustible vapors are suspected Lower explosive limit (10% LEL).
3. If
energized equipment is contained in the space, personnel should
refer to procedure number 10 in the Physical Plant Department
Policy and Procedure Manual (Energized Equipment Lock-Out/Tag-Out
Procedure) before entry. This procedure should be followed before
entry is allowed.
4. When
entry is made into the space there will be a minimum of two personnel
present. One employee will enter the space while the other will
remain at the entry area with radio communication. The employee
standing by (the Attendant) is not to enter the space for any
reason unless additional personnel are available for standby.
They are to notify the proper authorities in the event of a mishap.
This is to be done by notifying the Department for Facilities
Management and then notifying the Murray Fire Department at 911.
NO
RESCUE IS TO BE ATTEMPTED
BY
THE STANDBY (ATTENDANT) PERSONNEL!
5. Personnel
have two options after entry into the space:
a) They
can continuously vent the space.
b) They
may monitor the space continuously.
If any type
of "Hot Work" is to be performed in the space a "Hot
Work Permit" is to be issued along with the entry permit.(
These are two different permits and both are needed when
hot work is being performed. ) These "Hot
Work Permits" are to be issued only by the Department
supervisor under which the employees work under.
6. Before
reentry is allowed into the space; ALL the preceding
steps are to be completed again.
Example:
If a crew leaves the space for any period over 15 minutes, then
the space should be treated as an unknown hazard area and all
the steps must be completed again.
7. The
"Confined Space Entry" checklist shall be followed before
entry into a suspected hazardous area within a confined space.
If an area is suspected to be of a hazardous nature, personnel
shall notify their immediate supervisor and the Assistant Director
of Environmental Safety and Health before proceeding.
8. Failure
to follow these procedures could result in disciplinary aciton as
outlined in Section VI-D of the Murray State Personnel Policies
and Procedures Manual.
DUTIES &
RESPONSIBILITIES OF PERSONNEL
1.
AUTHORIZED ENTRANTS -
1) Know
the hazards that they may encounter, including the signs and
symptoms of these hazards.
2) Properly
used the assigned equipment.
3) Communicate
with the attendant as necessary to enable the attendant to monitor
entrants status and enable the attendant to alert the entrantf
the need to exit the space.
4) Alert
the attendant whenever:
a) the
entrant recognizes any warning signs or symptoms of exposure
b) the
entrant detects a prohibited condition.
5) Exit
from the space as quickly as possible whenever:
a) an
order to evacuate is given by the attendant or the entry supervisor
b) the
entrant recognizes any warning sign or symptom of exposure
to a dangerous situation
c)
the entrant detects a prohibited condition
2.
ATTENDANTS
1) Know
the hazards that may be faced during entry, including information
on the mode, signs, or symptoms, and consequences of the exposure.
2) Is
aware of possible behavioral effects of hazard exposure in authorized
entrants.
3) Continuously
maintain an accurate account of authorized entrants in the permit
space and ensures that the means used to identify authorized
entrants accurately identifies the entrants.
4) Remains
outside the permit space during entry operations until relieved
by another attendant.
5) Communicates
with authorized entrants as necessary to monitor entrant status
and to alert entrants of the need to evacuate the space.
6) Monitors
activities inside and outside the space to decide if it is safe
for entrants to remain in the space and orders the authorized
entrants to evacuate the permit space immediately under the
following conditions:
a)
if the attendant detects a prohibited condition
b)
if the attendant detects the behavioral effects
of hazard exposure in authorized entrant
c)
if the attendant detects a situation outside the
space that could endanger the authorized entrant
d)
if the attendant cannot effectively and safely
perform all the duties required.
3.
ENTRY SUPERVISOR -
1) Know
the hazards that may be faced during entry, including information
on the mode, signs or symptoms, and the consequences of the
exposure.
2) Verifies,
by checking, that the appropriate entries have been made on
the permit, that all test specified by the permit have been
conducted and that all procedures and equipment specified by
the permit are in place before endorsing the permit and allowing
entry to begin.
3) Terminate
the entry and cancels the permit.
4) Verifies
that rescue services are available and that the means for summoning
them are operable.
5) Removes
unauthorized individuals who enter or attempt to enter the permit
space during entry operations.
6) Decides
whenever responsibility for a permit space entry operation is
transferred and at intervals dictated by the hazards and operations
performed within the space, that the entry operations remain
consistent with terms of the entry permit and that acceptable
entry conditions are maintained.
Failure
to follow these procedures could result in disciplinary action as outlined
in Section VI-D of the Murray State University Personnel Policies
and Procedures Manual .
|